Господа, помогите вот такую картину вижу при прошивке телефона

Device synchronized.
Injecting EBL-Loader (RPSI).
Injecting EBL
Boot-loader is active
EBL version: 2150_OD_KH2_3.1 3..1
Boot mode is: BB
Using: Faster CRC, Writing all blocks , Skip data CRC , Skip protocol CRC
Package length is 16384 - protocol: 3.32
Baud rate set to 921600
Get flash id.
Flash ID is: 003000EC
Boot process finished

Start downloading item 'CUST:temp_GT-C3332_OXE.dffs'' from file 'C:\Documents and Settings\maps77\Мои документы\Downloads\123\C3332XEKK3\C3332OXEKK1_CSC .dffs''.
Sending sec-pack.
Load region 0
- Sending data.
Process time was 32.0 sec.

Stopped at 0% total, 1% current
Timeout occured during packet reception
The phone did not answer within the timeout period. This could be that the communication is interrupted or that the target SW is in an endless loop.
Check the connection to the phone, battery etc. If the problem persists report the error to the developer.
Channel 1 is succesfully closed.

Я думаю;-возможно механика? Эта история происходит- в случае запуска пришивания с файлом - C3332OXEKK1_CSC.dffs. Без него шьет все из папки (оставшиеся 4 файла)без запинок. Кстати, раньше дисплей показывал и жизнь и флешь режим тела, сейчас о жизни только догадки и показания флешера.
подскажите что делать?