Geto-Dak
14.07.2013, 14:48
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [HTC Desire C (PL0110000) V1.0.4807.61567]
Connecting to the target...OK
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x106010E1, IR Length = 0x04 bits
Total IR length: 0x0004 bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x106010E1: Qualcomm MSM7225A, H/W Rev. #1
Подскажите с чем связана эта ошибка... питание подаю кабелем без батареи
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [HTC Desire C (PL0110000) V1.0.4807.61567]
Connecting to the dead body...OK
Detected dead body ID: 0x106010E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
со скоростью Sample игрался от максимума до минимума ~20kHz
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [HTC Desire C (PL0110000) V1.0.4807.61567]
Connecting to the target...OK
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x106010E1, IR Length = 0x04 bits
Total IR length: 0x0004 bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x106010E1: Qualcomm MSM7225A, H/W Rev. #1
Подскажите с чем связана эта ошибка... питание подаю кабелем без батареи
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [HTC Desire C (PL0110000) V1.0.4807.61567]
Connecting to the dead body...OK
Detected dead body ID: 0x106010E1 - CORRECT!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
со скоростью Sample игрался от максимума до минимума ~20kHz